Go to


The Go to feature allows you to position the selection of a resource according to the value of a heading.

There are:

  • Positioning the view on a resource.
  • Positioning the schedule at the start date or end of an event. (cf. Search)

This is possible in the following views:


Go to a resource

This is possible only on persistent headings.

This feature is accessible via:

  • A simple Right click on a heading > Go to.
  • Right click on the header of the view > Go to.

The following window will appear:

Then select the different characteristics of the request, then click on OK to run the feature.


Appear in this list all headings of the dimension on which the positioning can be performed.


A condition must be choosen from the list of possible conditions, depending on the type of heading:

  • Equal to.
  • Not equal to.
  • Contains.
  • Doesn't contain.
  • Begin with.
  • Doesn't begin with.
  • End with.
  • Doesn't end with.
  • Greater than.
  • Less than.
  • Greater or equal to.
  • Less or equal to.
  • Is included in.
  • Is not included in.


This is the desired value into the same type as the heading.

Go to an event

This feature allows you to position the visible schedule views to the start or end date of a given event.

It can be used:

  • On a Events view.
  • On the Events tab in the Properties window of a resource.

It is accessible via a simple Right click on an event > Go to > Start Date or End Date:

Then, the window closes and the planner is positioned to the start date or the end date of this event.

Translations of this page: