CONFIGURATION

Setting thresholds

The properties window for headings of the type Control Total and Operation is used to define one or more threshold values.

By clicking with the right hand button:

The following threshold definition window opens:

The add button is used to create different heading thresholds.

For each threshold the following information can be defined:

  • A value:

    • constant: in this case the value of this constant must be defined,

    • or for a heading whose type is numeric, a control total (persistent) or operations (persistent). This heading may have the same dimension or have a dependent dimension.

  • A coefficient, applied to this value,

  • A color, when the target value is reached,

  • Another color when the target value is exceeded,

  • The Target box is checked for a given threshold. This target is used to display a percentage or to calculate the remainder.

  • A restriction method:

    • None: no restriction

    • Warning: a warning message will be shown when the threshold is exceeded.

    • Prohibition: an error message will be shown when the threshold is exceeded.

Display remainder

The box Display remainder implies that the heading shows the difference between the objective set by the thresholds and the calculated current value.

If no threshold has been defined, this remainder is not used.

Display as percentage

The Display as percentage box implies that the heading shows the result of the division of the calculated value into the objective as defined by thresholds, multiplied by 100.

If no threshold has been defined, this percentage is not used.

ghostghostghostghostghost
loading table of contents...